The same rules apply to choosing Sig P365 SAS holster that applies to choosing a holster for the Sig P365. There are no real downsides to running it in a holster built for the Sig P365. That said, it will still work in a Sig P365 holster. Have a P365 SAS already? Have you gotten hands-on with one? Let us know what you think in the comments.The Sig P365 SAS is a very streamlined pistol. However, is it so much better at anything compared to the standard P365? You'll have to decide that for yourself. Some shooters could probably get more out of it, but it would be a lot harder to do compared to shooting a standard P365 or a P365XL. The key takeaway is the P365 SAS is a slicked-up pistol for shooting up close and personal. What we all took from it was it was best to just slingshot the slide rather than trying to find the button. If you're used to using the slide release (we said slide release, that's what it is, get over it internet) the Sig P365 SAS is going to be an adjustment. It might from a pocket holster but might not otherwise. If carried in a holster, we didn't really find that the lack of a front sight or the recessed controls created a huge advantage in terms of not snagging on clothing compared to the standard gun. The sights also obscure the target, since they're so close to the top of the slide. We found they are quick to align at close range, but aren't terrifically useful past about 10 yards or so without a lot of practice. You, of course, get to decide for yourself whether it does or not. We think the SAS has a place, but we didn't see how it was so much better (in certain regards) that it really justified opting for it over the standard P365. Several of us took the P365 SAS to the range to shoot it and run the gun a bit to get a flavor for it, as we do with most of our reviews. Some might say it's an interesting experiment in how minimalist you can make a gun and still have it be usable.and they have one too. Some might accuse the Sig P365 SAS to be more flash than sizzle, more style than substance.and they'd have a point. The result is the sides of the pistol are almost entirely smooth, with little to snag on clothing or otherwise. The good news is that there are plenty of Sig P365 SAS holsters to choose from, and the SAS should fit most standard P365 holsters in any case. The slide stop/slide release lever is also recessed almost entirely into the frame, barely protruding enough to be used. A screwdriver, cartridge or other tool has to be used to rotate the bolt to take the pistol down. The takedown lever is changed to a flathead bolt with an offset notch in the bolt head. The front sight dovetail is merely left off the end of the slide is smooth. Sig Sauer cuts a trench into the top of the slide, with a rear notch to get a sight picture. The sight is available for other pistols, but installation is normally to drift it into the rear sight dovetail. To reduce the chance of snags, the Meprolight FT Bullseye sight is set into a trench in the top of the slide. Granted, it's hardly that the Sig P365 had obnoxious controls or sights the size of an M16A1s, but apparently it was a desired improvement. The SAS stands for "Sig Anti Snag," with the idea being that the lower-profile sights along with other improvements will make the Sig P365 easier to draw without snagging on anything. Since the images are aligned with the barrel, you have to get the gun aligned on target to get them to line up, almost like using a red dot. When you look through the sight, align the front dot with the rear ring.sort of like a bullseye, hence the name. Daylight illumination comes from the fiber optic, and the tritium illuminates the sight at night. The way FT Bullseye sights work is there's a tritium ring in the rear of the sight and a tritium dot at the front, with a clear fiber optic aperture in the middle. The SAS uses Meprolight FT Bullseye sights, which are fairly novel as far as things go. The real difference, of course, is the sights. Such a big difference, isn't it? It's a tiny bit shorter and a teensy, tiny bit narrower, and certainly not enough to write home about in any case. The different sights make the SAS 0.2 inches shorter and. It uses the same magazines, the same barrel, pretty much the same everything except for the sights and the control buttons. There aren't any major differences in terms of specifications, because everything is basically the same as the standard P365.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |